help with pulsevu 2x

[alxben95]

Hi i just got my pulse vu 2x today and i dont know were to conect the po ar al point on the newer xbox box with hdmi? can someone pls show me a pic of the layouts?
p.s can i hook up the positve ends om my leds to a 12v source and the neg to the vu on the chip? or does it have to be with the same 5v power source as the chip?
p.s and do i need to wire the po? or can i skip it?

[WorldFormula]

Its the same points as the elite. And the LEDs you need to figure out, they can be wired parallel or series and may or may not need a resistor based on the voltage you're using. The PO is necessary.

[th0rxx]

voltage for leds doesnt effect ur pulse vu 2x cos u use resistors to bring the voltage down. if u go here http://diy.sickmods.net/Our_Products/PulseVU/Install/360/ there all instructions for installation including the bridging of pin 22 and 24 of video port. as for supply voltage for leds ur goole to find them u want an unswitching supply theres a 5v 1w and a 12v on bottom of power plug. if more than 20 leds use 12v amp draw will b to high on 5v.